netta 103089, Инструкция пользователя и руководство по установке, Страница: 11 / 16

Before Starting Work
Before first use, fully charge the battery. Use only the original charger
included in the set. When charging, one red LED light will be on
– the
remaining LEDs will be off.
1. Connect the power cord plug with the charger into the charging jack.
2. Plug the charger into an AC outlet. Make sure that the voltage of the
electrical outlet is compatible with technical requirements.
3. When charging, the red LED will be on.
4. The recommended charging time is 5 hours and 30 minutes (for a
completely discharged battery). The battery is fully charged when
green LEDs are on. Your tool is then ready to use.
5. Once charged, first remove the charger from an AC outlet and then
unplug the charger from the charging socket.
Caution ! When charging, the handle of the device may heat up. This is
normal. Please wait until the handle cools down before using the device.
Switching On and Off
1. To switch the tool on, slide the lock-off button and push the on/off
button at the same time.
2. Release the lock-off button.
3. To switch the tool off, release the on/off switch. Once switched off,
the blades will keep moving for some time. Wait until the blades stop
completely. Do not touch moving blades and do not try and stop
them.