NetModule NG800, Руководство пользователя

Страница: 28 / 223

NG800
User Manual for NRSW version 4.5.0.100
4. Installation
The NG800 is designed for mounting it on a wall or in a switch cabinet. Please consider the safety
instructions in chapter
2 and the environmental conditions in chapter 3.3 .
The following precautions must be taken before installing a NG800 router:
– Avoid direct solar radiation
– Protect the device from aggressive fluids
Attention: NetModule routers are not intended for the end consumer market. The
device must be installed and commissioned by a certified expert.
4.1. Installation of SIM
NG800 with IP69K protection housing cannot be opened and contain a eUICC chip (eSIM) which re-
places the conventional SIM card. This embedded SIM allows the user to switch network/provider
profiles per software configuration without physically exchanging a SIM card. In other words eUICC
enables remote switching of SIM profiles.
For evaluation purposes NG800 can be shipped with a housing which can be opened (IP55 protec-
tion). These devices contain a Micro-SIM card connector, where a SIM card can be inserted.
Warning
– The IP55 housing may only be opened by qualified personnel.
– Please request instructions for SIM change.
4.2. Installation of the GSM/UMTS/LTE Antenna
NetModule routers will only operate efficiently in the cellular network if there is a good signal. Use
remote antennas together with an extended cable (max. 3 meters) to reach a location offering an
adequate signal. In doubt, please contact us and we would be pleased to assist you in figuring out the
best matching antenna setup for your application.
Keep in mind that effects caused by Faraday cages such as large metal surfaces (elevators, machine
housings, etc.), close meshed iron constructions and others may reduce signal reception significantly.
The antenna or antenna cable (max. 3 meters) has to be mounted to the MOB ports A1 and A2 which
should be fixed with a wrench. A1 is the main, A2 the auxiliary port.
28