Mounting the Outdoor
CPE in a Pole or Tower
Netkrom CPE device can be mounted on the
pole or tower as shown in following:
1.-
Attach the mounting bracket to the back
of the CPE using the three hex screws
provided. (Do not over tighten the screws.)
Note
:
The bracket in the illustration side
shows the normal orientation which allows
the CPE to be pointed up towards the base
station antenna. However, if you live
somewhere that would require you pointing
the CPE down towards the base station
antenna (for example, you are on the side of
a mountain in view of the base station
antenna below), reverse the bracket so the
Netkrom CPE Unit can be “tilted”
downward when you aim the CPE in a later
step.
bolts are
approximately 1/4" from the end.
to adjust the CPE
direction in a later step.
a, then hand-tighten the nuts on the U-
bolt.
3.-
Remove the U-bolt and pipe bracket
assembly from the plastic bag. Place the
washer, lock nut to each side of the U-bolt,
and then tighten until the U-
Note
: Do not tighten the screws all the way
because you will need
4.-
Mount the CPE to the top of the pipe or
other support and point the CPE in the
approximate direction of the base station
antenn
