NETGEAR Smart Switch GS752TXS, Руководство по установке оборудования

Страница: 13 / 36

Chapter 2. Physical Description | 13
GS752TXS Smart Switch Hardware Installation Guide
• Four dedicated 1000 Mbps/10Gbps SFP+ Gigabit Ethernet switching ports. Up to two of
these ports (ports 51 and 52) can alternatively be used as stacking ports.
• Reset button to restart the device
• Recessed default reset button to restore the device back to the factory defaults
• Link, Speed, and Activity LEDs for each port
• Power, Fan Status, Stack Master, and Stack ID LEDs
Figure 3 illustrates the NETGEAR GS752TXS Smart Switch back panel.
Figure 3. Back Panel
The back panel contains a power connector.
LED Designations
Port LEDs
The following table describes the RJ-45 and dedicated SFP port LED designations. There
are two LEDs for each RJ-45 port.
Each SFP port has its own indication LED.
LED Designation
Link/Speed/ACT LED mode for
copper ports 1 to 48 • Off — No link established.
• Solid Green — A valid 1000 Mbps link is established.
• Blinking Green — The port is transmitting or receiving packets at
1000 Mbps.
• Solid Yellow — A valid 10/100 Mbps link is established.
• Blinking Yellow — The port is transmitting or receiving packets
at 10/100 Mbps.
Link/ACT LED for SFP+ ports
49 to 52 • Off — No SFP+ module link is established
• Solid Green — A valid 10 Gbps link is established.
• Blinking Green — The port is transmitting or receiving packets
at 10 Gbps.
• Solid Yellow — A valid 1000Mbps link is established on the port.
• Blinking Yellow — The port is transmitting or receiving packets at
1000 Mbps
Power Connector