40
|
Chapter 2. Installation and Configuration
ProSafe Wireless-N Access Point WNAP320 Reference Manual
Configuring the RADIUS Server Settings
You can set p or modify the RADIUS server settings to compliment network authentication
security options. The RADIUS server must be used with Legacy 802.1x, and can be used
with WPA and WPA2 network authentication. When using a RADIUS server, the RADIUS
server settings before completing the network authentication security profile (see
Configuring
WPA with RADIUS
on page
68,
Configuring WPA2 with RADIUS
on page
70, or
Configuring
WPA and WPA2 with RADIUS
on page
73 for specifics on implementing these security
options).
Note:
The RADIUS server settings apply to all profiles. They o need to be
configured only once per product family.
To set up or modify the RADIUS server settings:
1.
From your Web browser, log in to the WNAP320 using the default LAN address of
http://192.168.0.100
, user name
admin
, and password
password
, or use the LAN
address and password that you set up.
2.
Select
Configuration
>
Security > Advanced >
RADIUS Server Settings
. The RADIUS
Server Settings screen displays, as shown in
.
Figure 13.
3.
Enter the following RADIUS server settings:
•
Authentication Server.
This configuration is required for authentication using a
RADIUS server.The IP address, port number, and shared secret are required for
communication with the primary RADIUS server. You can also configure a secondary
RADIUS server to use, if the primary RADIUS server fails.
-
IP Address.
The IP address of the RADIUS server. The default is 0.0.0.0.
