August 2014
NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134, USA
NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered
trademarks of NETGEAR, Inc. and/or its subsidiaries in the United States and/or other countries.
Information is subject to change without notice. © NETGEAR, Inc. All rights reserved.
2. Enter
admin
for the user name and
password
for the password.
3. Click the
Login
button.
The web management interface displays.
4. Click the
Web Browser Access
button.
The Router Status screen displays.
5. Configure the VPN firewall for your network.
For more information, see the software administration guide.
Troubleshooting Tips
Following are some tips for correcting common problems you might
encounter:
•
Make sure that the Ethernet cables are securely plugged in.
The WAN Link/ACT light on the firewall is lit if the Ethernet cable to the
firewall from each modem is plugged in securely and the modem and
firewall are turned on. For each powered on computer connected to the
firewall with a securely plugged in Ethernet cable, the corresponding
firewall LAN port LED is lit.
•
Make sure that the network settings of the computer are
correct.
Computers must be configured to obtain IP and DNS addresses
automatically via DHCP. For information about configuring your
computer to obtain an IP and DNS address via DHCP, see the reference
manual.
•
For cable modem connections, use MAC spoofing.
Some cable modem ISPs require that you use the MAC address of the
computer registered on the account.
Support
Thank you for selecting NETGEAR products.
After installing your device, locate the serial number on the label of your
product and use it to register your product at
https://my.netgear.com
.
You must register your product before you can use NETGEAR telephone
support. NETGEAR recommends registering your product through the
NETGEAR website. For product updates and web support, visit
http://support.netgear.com
.
NETGEAR recommends that you use only the official NETGEAR support
resources.
For the current EU Declaration of Conformity, visit
http://support.netgear.com/app/answers/detail/a_id/11621/
.
For regulatory compliance information, visit
http://www.netgear.com/about/regulatory/
.
See the regulatory compliance document before connecting the power
supply.
¾
To use MAC spoofing:
1. Select
WAN1 ISP Settings
>
Advanced
.
2. In the Router’s MAC Address section select either Use this Computer’s
MAC or Use this MAC address.
3. Enter the MAC address of the computer that is registered with your ISP.
The router captures and uses the MAC address of the computer that
you identified.
4. Click the
Apply
button.
Your settings are saved.
5. Restart the network in the correct sequence.
