NETGEAR CGD24N, Руководство пользователя

Страница: 25 / 84

DOCSIS 2.0 Advanced Cable Gateway CGD24N v2 User Manual
Wireless Configuration 2-5
v1.0, August 2009
Configuring WEP (Wired Equivalent Privacy) Wireless Security
Table 2-1. Wireless Settings
Settings Description
Wireless Network Name (SSID) The SSID is also known as the wireless network name.
Enter a 32-character (maximum) name in this field. The
characters are case-sensitive.
In a setting where there is more than one wireless
network, different wireless network names provide a
means for separating the traffic. Any device you want to
participate in a wireless network must use the SSID.
Region Specify the region where the gateway will operate.
Channel The wireless channel used by the gateway. The default
is channel 1.
You should not need to change the wireless channel
unless you experience interference (shown by lost
connections and/or slow data transfers). Should this
happen, you may need to experiment with different
channels to see which is the best.
802.11 Mode 802.11b/gNext
2.4 GHz, Auto, 40 MHz?
Security Options You can manually configure wireless security here.
•
Disable . Wireless security is disabled by default. After the gateway is connected to
the Internet, NETGEAR strongly recommends that you implement wireless security.
• WEP (Wired Equivalent Privacy) 64-bit encryption or 128-bit encryption . WEP
provides data security with WEP Shared Key authentication and WEP data
encryption. You can select 64-bit or 128-bit encryption. See
“Configuring WEP (Wired
Equivalent Privacy) Wireless Security” on page 2-5 .
• WPA-PSK . WPA-PSK uses the TKIP encryption type with authentication from a
RADIUS server.
• WPA2-PSK . WPA2-PSK uses the AES encryption type with authentication from a
RADIUS server.
• WPA . Wi-Fi Protected Access (WPA) data encryption provides data security. The very
strong authentication along with dynamic per frame rekeying of WPA make it virtually
impossible to compromise. .
• See “Configuring WPA or WPA2 Wireless Security” on page 2-7 .
Note:
If you use a wireless computer to configure wireless security settings, you will be
disconnected when you click Apply. Reconfigure your wireless computer to match
the new settings, or access the gateway from a wired computer to make further
changes.