NetComm V422, Быстрый старт

Страница: 18 / 19

18
Copyright
©
2012. All Rights Reserved.
9. How to access V431 IVR?
a)
FXS Port
1) Connect the Gateway to the telephones as required.
2) To access the gateway via IVR, pick up the handset and press ***4144534954#. Convert your password
to a numerical sequence.
3) After entering a correct IVR password, you will hear a indication tone which is beep tones
4) About approximate 1 second apart, now the system is in IVR mode. Enter function codes to
5) Check or set the gateway configurations.
6) For example: The factory default IVR access password is “admin”. Enter ***4144534954#, you are now
in IVR setting mode, enter a function code to check or configure the gateway. If your password is “1234”,
then enter **1234# to enter IVR setting mode.
b) FXO Port
1) Connect the Gateway to the PSTN line as required.
2) To access the gateway via IVR, dial the phone number of the FXO Port using an external line. You will
hear the instruction “enter value”.
3) Enter the IVR password. The factory default code is “admin”. Enter ***4144534954# as above. You are
now in the IVR setting mode. Refer to the IVR Function Table over the page for the query codes.
4) Once the first setting or query has been completed, you will hear the tone indication again. Then use the
same procedure to make a second query or setting.
5) Dial 509 to save the settings and wait for about 3 seconds for the confirmation tone. To exit IVR mode,
simply hang up the phone.
10. How to customize greeting message?
The gateway allows users to record their incoming call greeting message, when calling via FXO (transit-in
calls).To record greeting message, the instruction is show below:
1) Pick up the handset that connected to FXS port;
2) Enter ***4144534954#
3) —After entering IVR mode, dial 132. After hearing “Enter value”, record the incoming call greeting
message.
4) Simply hang up to end recording.
5) Goes to V431 Web Interface, click “Telephony Settings” tab, To use (activate) recorded greeting voice for
transit-in calls, choose “Recorded voice file” option in “Trunk Incoming Prompt Voice”.
6) Save the settings, and then restart the system. Wait for about 40 seconds for the system to restart.
11. How to force calling through PSTN line?
Dial the code to get a PSTN line for dial out. For example: The default setting is “##” in this option and would like
dial “23456789” through PSTN, just dial “## 23456789”.
You can change it to other value that you want, Go to V431 Web Interface, click “Telephony Settings” tab -
change the value in “Force Calling Thru PSTN Code”.
Save the settings, and then restart the system. Wait for about 40 seconds for the system to restart.