NetComm V100LS, Быстрый старт

Страница: 12 / 40

V100LS User Guide YML739Rev1
12 www.netcomm.com.au
Option B - Optus/Telstra Cable Internet Connection
Connect the V100LS ATA to your Cable modem as illustrated in the following diagram:
Figure 2 - Connecting the V100LS ATA to a Cable Modem
Note: A Router with a switch is required. If your router does not support DHCP please
refer to Appendix C of this manual for instructions on how to configure the V100
ATA.
1. Connect the Phone socket on the rear of your V100LS ATA to an analogue telephone using
a RJ-11 cable.
2. Connect the WAN socket on the rear of your V100LS ATA to the Ethernet port of your
Cable modem or one of the LAN ports of your router/switch using a Category 5 cable.
Note: If you connect the WAN socket directly to your Cable modem, you will not be
able to connect a computer. To connect multiple devices to your cable modem,
you will need a router or switch.
3. Connect the POWER socket on the rear of your V100LS ATA to the power adaptor
supplied and plug into a wall socket.
4. Everything required to connect to the VOIP network is preprogrammed into your V100LS
ATA. To make and receive calls, simply pick up the handset of your connected Analogue
Telephone and make the call. Your new MyNetFone VOIP number can be located on the
base of the V100LS ATA unit.