Note:
To use PoE (Power over Ethernet), the Wireless Access Point
should be connected as shown below, rather than using steps 2
and 3 above.
4.
Check the LEDs:
•
The
Status
LED should flash, then turn OFF.
•
The
Power
,
Wireless LAN
, and
LAN
LEDs should
be ON.
3. Access Point Setup
The default settings are:
IP Address
Automatic (DHCP Client)
If no DHCP Server is detected,
the IP address is 192.168.0.228
SSID
wireless
Wireless Security
Disabled
If you need to change these, follow this procedure.
1.
Check the Wireless Access Point to determine its
Default
Name
. This is shown on a label on the base or rear, and is
in the following format:
SCxxxxxx
xxxxxx
is a set of 6 Hex characters (0 ~ 9, and A ~ F).
2.
Use a PC which is already connected to your LAN, either
by a wired connection or another Access Point.
Page 4
