Net2Edge LIB-225, Быстрый старт

Страница: 9 / 17

Net2Edge | Liberator™ CE Quick Start Guide 9
Once the new interface is set up, you will have to configure the port VLAN settings to complete
the process. To do this you must go to
Configuration > VLANs
.
•
For the management traffic the port you intend to use should be set to ‘
Access
’ – the
‘Port VLAN’ field should contain the ID you set up under the IP interface. Please ensure
that you add the VLAN ID to the ‘
Allowed Access VLANs
’ field at the top of the page
•
In the event you are using Dual IP and have a separate IP interface set up for the CES
traffic, you will need to set the port you want to use to the following;
o
Mode
: Trunk
o
Port VLAN
: <ID you used to set up the IP interface>
o
Port Type : C-Port (can’t be changed under this Mode)
o
Ingress Filtering
: Selected (can’t be changed under this Mode)
o
Ingress Acceptance
: Tagged and Untagged (can’t be changed under this Mode)
o
Egress Tagging : Untag Port VLAN
o
Allowed VLANs
: 1-4094 (this can be shortened to match your VLAN ID)
Please note
: If you need to customise the port type or the Ingress filtering and acceptance,
you can do so by setting the mode to ‘
Hybrid
’.
4.3. Setting up a logical link
To use the Circuit Emulation features, the first setup step is to set up a logical link between a
minimum of two PacketBand units – this link will carry the TDM data across a packet switching
network.
To do this you must go to the logical link sub menu which is located here
:
Configuration > CES > Link > Settings