shows through the MUM2000-2 port opening with the UIM-1000F model name along the right-
hand edge.
z
Ensure that the mounting holes on the UIM-1000F are lined up with the corresponding pems
on the MUM2000-2 circuit board and that the board-to-board connector key pins are properly
aligned.
z
Gently press down on the back end of the UIM-1000F, over the board-to-board connector. You
will feel a slight click as the connector becomes fully seated.
z
Secure the UIM-1000F circuit board to the MUM2000-2 circuit board, at the pems, with the (4)
provided panhead screws.
z
Secure the UIM-1000F faceplate to the MUM2000-2 faceplate using the (2) provided beige
flathead screws.
1.3 Install the MUM2000-2 in an IP DSLAM Chassis.
The IPD12000 is a fourteen slot chassis; slots 1-12 are reserved for interface modules and slots 13-
14 are reserved for multiplexer uplink modules (MUMs). The IPD4000 is a five slot chassis; slots 1-4
are reserved for interface modules and slot 5 is reserved for a MUM.
z
Align the MUM2000-2 with the slot module guides of the chosen slot for installation (either slot
13 or 14 on the IPD12000 or slot 5 on the IPD4000).
z
Slide the MUM2000-2 firmly into the chassis. DO NOT USE EXCESS FORCE.
z
Tighten the fastening screws on the MUM2000-2 faceplate.
z
Verify that the PWR (Power) LED on the MUM2000-2 faceplate is illuminated.
2.0 ESTABLISH THE ETHERNET UPLINK CONNECTION
The UIM-1000F fiber optic port is a 1000Base-X, full duplex Gigabit Ethernet port. 1000Base-X indicates a
1000 Mbps (1 Gbps) Ethernet connection over fiber optic cabling and complies with the Institute of
Electrical and Electronics Engineers (IEEE) network standard 802.3z. Full duplex indicates the ability of the
ethernet port to receive and transmit data simultaneously.
2.1 Small Form Factor Pluggable Modules
In order for the UIM-1000F fiber optic port to have the capability of supporting both single mode fiber
(SMF) and multi-mode fiber (MMF) connections, it requires a small form factor pluggable (SFP)
module. These modules must be ordered separately from Net to Net Technologies; see your Net to
Net Sales Representative for further information.
220-0000080 rev 01
