Net 1 N123201, Руководство по сборке, Страница: 8 / 17

Step 1: Pole assembly
Pull the Top Pole (G) up through the Upper Middle Pole (F) far enough
to clear the holes near the bottom of the Upper Middle Pole (F).
Top pole (G) has ten holes (5 each side) for the height adjustment, and
six holes (three
The upper middle pole (F) has two square shaped holes opposite each
other at the top of the pole for the height adjustment and two round
Position the Top Pole (G) at its lowest height setting and insert one
carriage bolt ( T ) into the square hole at the top of the Upper Middle
Pole (F) and through the Top Pole(G). Secure with washer (M)
Note: The Adjustment Knob (J) will face towards the rear of the
basketball system base.
Align the slot in the Lower Middle Pole (E) with the hole
in the Upper Middle Pole (F) and slide the Upper
Middle Pole (F) over the Lower Middle Pole (E).
The lower middle pole (E) has one slot at the top of the pole
and one hole near the bottom end.
Insert one Pole Joint Screw (X) through the small hole in
the Upper Middle Pole (F) and in to the Lower Middle
Pole (E).
Note: The Pole Joint Screw (X) will spin freely once
installed.
Align the slot in the Bottom Pole (D) with the hole in the
Lower Middle Pole (E) and slide the Lower Middle Pole
(E) over the Bottom Pole (D).
Base pole (D) has one slot at the top of the
pole, two holes in the middle and one nut inside
the bottom end.
Insert one Pole Joint Screw (X) through the small hole in
the Lower Middle Pole (E) and into the Bottom Pole (D).
Note: The Pole Joint Screw (X) will spin freely once
installed.
Do not jam the poles together until instructed.
T
G
F
M
J
X
X
E
D
goal
holes towards the bottom of the pole.
adjustment knob (J).