Page 7
The Battery Box is already equipped to use solar panels and/or wind genera-
tors, which simply connect to the small white connectors in the Electronic
Battery Box.
Route all the cables entering the Battery Box through the cable slot in the base
of the box. Secure the front of the box using the 4 plastic pegs (which should
be inserted fully, and then turned 90
⁰
with a screwdriver to lock).
4.3
Set up the Receiver and Connect to TV
Screw the Antenna onto one end of the Receiver.
Adjust the angle of the Antenna so that it is ap-
proximately vertical. The receiver can be
mounted vertically using the screw holes pro-
vided, or rested in a horizontal position. Adjust
the angle of the Antenna so that it is approxi-
mately vertical.
Fit the 9V Mains Power Supply (it has a cylindri-
cal plug) to the Receiver (DC 9-12V) and plug it into the Mains. Switch the
power on. The red indicator light will show it is on.
Fit one end of the Receiver Video/Audio Lead to the Receiver, connecting
yellow to “VIDEO OUT” and white or red to “AUDIO OUT”.
Fit the other end of the Receiver Video/Audio Lead to the direct input video/
audio of your TV. Connect yellow to video in, and white or red to an audio in
socket.
As an alternative, you may prefer to fit this in to the Video/Audio connectors
on a video recorder or VCR.
If you only have a SCART input socket for your TV, you can fit the cable
through an appropriate adaptor (available from our accessories range).
The cable (and the signal it carries) is not suitable for direct connection to
your TV aerial or antenna socket.
Turn the TV on, and switch it to the direct video/audio input.
Page 5
SCREW ANTENNA
ONTO RECEIVER
