Assembly instructions
The Eco Dipper
-
Wagtail Nest Box is sup-
plied flatpacked but is designed to be
quick and easy to make into the box.
Check you have all the parts of the box.
The centre panel has 6 tabs on each side which fit
through the slots in the side panels. Before the three
panels can be put together the tabs on the centre pan-
el need to be bent slightly. One side of the central
panel has two trenches cut into it and the other does
not. With the trenches facing up, push the tabs down
and away from you . They only need bending by about
20 degrees so they fit through the slots in the side
1.
2.
3.
4.
Finally to finish off the box and get it ready to mount
in position bend the mounting brackets out ward so
so they are about at 90 degrees. Then fix the box in
position with the supplied stainless steel screws or a
suitable alternative depending on the surface the
box its being attached to.
Next attach the three panels together. Start by bending
the centre panel along the trenches (the trenches
should face into the box) so the tabs line up with the
slots in the side panels. With the slots lined up push the
side panels on to the centre panel. The side panels
should have the trenches near the mounting holes fac-
ing outwards. When the panels are all together bend
the tabs back to their original position to hold the box
together.
Tre
nch
Right Side
Centre
panel
Left Side
Tab
6 x Screws
