listen-in Mode
INstaLLer’s dIaGNOstICs.
apply a shorting link to J6 to enable Listen-in
mode.
all dialler activity will be heard via the onboard
piezo sounder.
Test Calls
SecurityGuard II:
test calls are sent weekly to the
central station. the time interval is fixed. the first
test call is sent 14 hours after leaving program
mode or after powering up the radio dialler.
SecurityGuard III:
test calls can be programmed in
intervals 1 day, 7days, 14 days, 30 days or OFF.
Remote Programming
the radio dialler can be programmed remotely
via PC and Ness upload/download software.
remote programming can used either to:
a/ reset the One shot programming option
allowing the technician to reprogram the radio
dialler via the securityGuard.
b/ Or the phone1, phone2 and client numbers
can be remotely downloaded to the radio dialler.
Note, in this case, the numbers programmed in
the securityGuard may be different to the radio
dialler.
reMOte PrOGraMMING
1. ensure radio dialler is powered up.
2. Power up sGIII and press OFF to enter
PrOGraM mode. radio dialler will now be ready
to answer incoming calls for the next 5 minutes. If
the dialler answers a call but does not verify within
30 seconds it will hang-up. Once a connection is
established, the dialler will unconditionally hang-
up after 5 minutes if a hang-up is not requested
sooner by the remote end.
3. Once a connection is established, program
the sGIII/radio dialler system as required.
sGIII will exit PrOGraM mode when the up/
down connection is terminated, or when the
sGIII PrOGraM mode timer expires, whichever
occurs first. If PHONe1 has been programmed,
then if data transfer to radio dialler has not been
successful within a short period, sGIII will raise
a system alarm indicating radio link failure with
the dialler.
Dialling Method
the radio dialler auto-detects the dial tone and
dials in dtMF or rotary as determined by the
dial tone.
In cases where the dial tone is undetectable or
non-standard (such a stutter-tone) the radio
dialler can be forced to dial in dtMF always.
Place a shorting link across pins 2 & 3 of the
J7 header on the main board to force dtMF
dialling.
Place a shorting link on
pins 2 & 3 of J7 to force
dtMF dialling.
SecurityGuard Supervision
the integrity of the radio link between the
securityGuard and the radio dialler is tested
by a supervision poll sent by the securityGuard
every 90 minutes.
If the radio dialler fails to receive eight consecutive
poll messages it will send a radio Jamming alarm
to the central station (Contact Id 355-105).
a restore message is sent when the radio dialler
receives the next valid poll.
Place a shorting link on J6
to enable Listen-in Mode.
Radio PIR Supervision
supervised detector (380) sensor trouble
message including the device number is sent the
sGIII fails to see 24 consecutive polls from the
device. the restore will be sent when the device
a poll message or is next triggered.
