Nesco NC-59101, Инструкция по эксплуатации

Страница: 19 / 26

10.
11.
12.
13.
14.
15.
16.
17.
18.
When using an extension lead, make sure it is 13 amps fused, and no longer
than 25 metres. If using acable reel, ALWAYS fully unwind the cable before
using (if left wound, it can generate heat and be a potential fire hazard). Only
use a cable that is recommended for outdoor use.
The water supply should provide a consistent pressure throughout the period
you are using the pressure washer. Make sure that , if the supply is shared by an
appliance which could affect the water pressure eg a washing machine wich
draws water on and off periodically through it’s programmer cycle, that the
appliance is not used whilst using the pressure washer.
Handle the lance with care, ensuring that the tip is not damaged eg striking
the ground in use.
The pressure washer should always be used in its upright position.
Pressure washers can be deceptively heavy, so take care when lifting.
NEVER connect the pressure washer to the hot water supply, as this will rapidly
reduce the life of the pump.
It is necessary to turn on the spray lance within one or two minutes after the
machine has been switchedon. Otherwise, the temperature of the water
circulating within the machine will soon rise to a critical point
and will cause internal damage.
When you have finished using the machine, use the safety button on the lance
handle to prevent the trigger from being accidentally activated .
It is highly recommended that you use a Residual Current Device (RCD) – not
suppliedwith this product, to provide you with maximum protection from the
risk of electrocution.
INSTRUCTION FOR USE
1.
2.
3.
4.
Stand the machine up, placed on a flat ground.
Check the water entry filler to make sure it is free of blockage.
Use detergent to make better wash.
Cut the soft hose. (see fig.1) put the hose into the hot water (about 70 c) and
let the hose to be softer, connect the soft hoses to joint of detergent tank.
(see fig.2)
fig.2 fig.1
18