Neschen PHOTOLAM 650, Инструкция пользователя

Страница: 9 / 11

9
12. SAFETY GUIDELINES
Any rotating or moving parts of the laminator and parts under electrical power may
cause severe or even fatal injuries. Installation, wiring, putting into service as well as
maintenance and repairs may be performed by qualified and trained personnel only.

The laminator may only be operated only by persons older than 18 years of age, mentally
and physically fit, duly instructed (with their knowledge verified) and authorised to operate
the laminator.

More demanding repairs and any work on the laminator’s electrical installation may be
performed only by an appropriately qualified person or by the manufacturer.

Laminator operators and maintenance workers must be well acquainted with these User
Instructions

Any adjustments, maintenance and cleaning of the laminator must be performed while the
laminator is idle, the main switches turned off and the machine disconnected from power
mains.

Start the laminator only when the covers are attached.

Never touch any moving parts of the laminator.

Safety instructions - Pictograms - to be attached legibly to the laminator.

Work only under good lighting conditions.

Before starting work, check the safety devices on the laminator and ensure that they operate
correctly.

Never work with the laminator when you feel tired.

Damaged parts at the laminator may only be replaced by authorised personnel. Use only
original parts.

Turn off the laminator in case of strong vibration, noise or other unusual signs and inform the
supervisor.

Do not wear loose clothing (e.g. tie) or long hair to prevent it from getting between the rollers
of the laminator.

Always stand firmly on the floor when working with the laminator.

Take special care after switching on the laminator and starting up the rollers.

Switch off the unit immediately and inform the supervisor in case of damage to the
insulation, smell of burning or loud noise during work on the laminator, if the machine jerks
after switching on, if individual parts of the electrical system are overheated, if sparks occur
or if current flow is felt.

If such hazards occur or if danger arises for the operator, switch off the laminator by
pressing the emergency STOP switch.

If someone detects that the operator of the lamnator is at risk, they can actuate the
emergency STOP switch.

After finishing work on the laminator, lift the upper roller, switch off the laminator and
disconnect the power supply.