Executive device Radio 8113 IР65
Passport
1
.
Purpose
The executive device Radio 8113 IP65 is designed to control
roller shutters, roller blinds, gate and barrier control units, sun
blinds, as well as lighting devices and with any other electric
load
with a current consumption of up to 3
A using the
remote controls of the Radio series.
187-253/50
20
3 (at cos=1)
1
433.05-434.79
1000
80x80x50
from -30 to +50
0,75
IP65
2
.
Specifications
Supply voltage range, V~/Hz
Consumption current, mA, not more than
Maximum allowable switching current, A
Number of controlled electric drives
Operating frequency range, MHz
Number of recordable codes of remote controls
Overall dimensions, mm
Operation temperature range, °С
Section of interconnecting wires, mm
2
Degree of enclosure protection
Protection class against electric shock
II
The product is not intended for installation and operating in explosion hazard and fire
hazardous zones and does not require the protective earth.
3. Peculiarities
- availability of potential-free contact for connection to automation of other manufacturers;
- control using the remote controls of the Radio series;
- retransmission of commands from dynamic remote controls;
- auto closing timer for rolling gates;
- emergency control of roller shutters, rolling gates.
4. Connection
Use wires with a cross-section of at least 0.75 mm
2
in double insulation to connect the device
to the network and to the electric drive.
It is prohibited to use mounting wires and cables with polyethylene insulation or sheath.
It is prohibited to install the device at a distance less than 1 m from heating devices.
The holes in feedthrough plate should be punctured using a tool
of smaller diameter than the
input cable.
It is prohibited to supply 220-230
V~ voltage to the terminals 8-15.
To consider 220
V~ as the nominal network voltage when delivered to Ukraine.
It is allowed to change the safeguard on the 5A rating when connecting the drives
with a current consumption more than 3
A.
5
. Programming of remote controls
Action
Indication
1. Input the device in programming mode of remote controls (PM of remote controls)
Press and hold the programming button for more than 4 sec
.
Visual indicator blinks red
.
2. Record the remote control channel in the memory of the device (PM of remote
controls)
Radio
8101-1M
a) in dynamic mode: press and hold the
remote control button for more than 2 sec.;
b) in static mode: press short the remote
control button (less than 1 sec.)
When recording the visual
indicator blinks short-long-
short green light.
If the remote control is
already recorded, the
indicator will flash green
shortly.
Radio
8101-2M
8101-4M
a) in dynamic mode: press and hold the
recordable
remote control button, and press
short any other;
b) in static mode: press short the recordable
button.
Antenna
Safeguard
Power supply
220- 230
V~
Fig. 1 Drive connection
Electric drive
Jumper 220-230
V~
Visual
indicator
Two-button
switch
“Programming” button
General/ground
Safety inputs
General/ground
Power 12 V/200 mA
