Nero 749040, Инструкция по эксплуатации

Страница: 3 / 4

PRODUCT ASSEMBLY
ASSEMBLY OF BASE

Firstly, loosen and remove the four screws from the bars. Then cross bar A and bar B so
that they interlock.

Be sure to align the four holes in the bars with those on the flange of the Outer Tube.
Secure the flange to the bars with the four screws.

Loosen and remove the Height Adjustment Collar from the top of the Inner Tube. Slide the
Base Decorative Cap down over the assembly.

Replace the Height Adjustment Collar on top of the Inner Tube. Pull the Inner Tube out from
the Outer Tube to adjust the tube to the desired height and tighten the collar.

If necessary, slightly loosen the Set Screw by turning it anticlockwise. Slide the Switch Box
down over the Inner Tube and tighten the Set Screw. Make sure the Set Screw is tightly
secured.
ASSEMBLY OF BLADE AND GRILL

Unscrew the plastic mounting nut from the front of the motor housing by rotating it
anticlockwise.

Position the rear grill against the front of the motor housing with the handle uppermost,
ensuing that the locating pegs on the motor housing are engaged correctly in the holes of
the rear grille.

Tighten the Rear Grill Mounting Nut clockwise. DO NOT OVERTIGHTEN IT .

Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the
drive pin that passes through the motor shaft.

Tighten the blade cap by turning it anticlockwise.

Position the front grill against the rear grill so that the holes in the rims that accept the small
nut and bolt are in line. Insert the bolt through the holes and screw on the nut. Do not fully
tighten at the stage.

Push the grill retaining clips into position ensuring that they engage correctly on the rim of
the grill.

Fully tighten the small nut and bolt that passes through the rim of the grill.
OPERATION OF THE PRODUCT

Place your fan on a level and dry surface.

Plug the fan in to a mains socket. Select the desired speed setting. There are 4 settings
– 0
(off), 1 (low), 2 (medium) and 3 (high).

The fan can be set to oscillate by pushing Oscillating Knob downwards. To stop the
oscillating feature, pull-up the Oscillation Knob.

To adjust the tilt angle of fan head, loosen the neck screw, swivel the fan to the desired
angle and then re-tighten the screw. Caution: The fan should always be switched off when
making this adjustment.
CLEANING

Switch off and unplug from the power supply before assembling or disassembling and
cleaning.

Keep the air vents at the rear of the main body free from dust or fluff
– use a vacuum
cleaner to remove these when necessary. Do not probe any opening to remove fluff.

Fan component parts should be cleaned using mild soap and a damp cloth or sponge. Do
not allow any water or other liquid to enter the motor housing.

Thoroughly remove soap film with clean water.
CAUTION: Do not use harsh detergents, chemical cleaners or solvents as they may
damage the surface finish of the fan components.
Backed by Nero's 12 month replacement guarantee
Imported By Weatherdon & Co Pty Ltd
www.weatherdon.com.au