Nerf C17DR00G0, Руководство пользователя и инструкции по установке, Страница: 23 / 44

Troubleshooting
en
23
Fault Cause and troubleshooting
"Appliance heating up" appears
on the display but the appliance
is not reaching the selected tem-
perature. Automatic calibration values are not optimal.
▶
Restore the appliance's factory settings and repeat the procedure for initial
configuration.
→
"Basic settings", Page 16
→
"Before using for the first time", Page 8
a
The next time you use the Steam function at 100 °C, the calibration process
will run automatically and more steam will be produced.
When cooking with steam, a lot
of steam is produced. The appliance is being automatically calibrated.
No action required.
When cooking with steam, a lot
of steam is produced and this
happens repeatedly. Appliance unable to calibrate itself automatically if cooking times too short.
▶
Restore the appliance's factory settings and repeat the calibration process.
Steam escaping from ventilation
slots during cooking. This is standard procedure.
No action required.
13.2 Replacing the cooking compartment
bulb
If the cooking compartment light has failed, replace the
cooking compartment bulb.
Note:
Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance gets very hot.
▶
Never touch the inside surfaces of the cooking com-
partment or the heating elements while they are hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Never touch the ventilation openings.
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
▶
Before replacing the bulb, unplug the appliance
from the mains or switch off the circuit breaker in
the fuse box.
Requirements
¡
The appliance must be disconnected from the power
supply.
¡
The cooking compartment must have cooled down.
¡
You must have a new halogen bulb to replace the
old one.
1. Turn the glass cover anti-clockwise to remove it ⁠.
2.
Pull out the halogen bulb without turning it ⁠.
3. Insert the new halogen bulb and press it firmly into
the socket.
Make sure that the pins are positioned correctly.
4.
Slide the new seals and the clamping ring onto the
glass cover in the right order.
5.
Screw the glass cover with the seals back on again.
Never operate the appliance without the glass cover
and seals.
6.
Connect the appliance to the power supply and fol-
low the initial configuration procedure again.
13.3 Replacing the glass cover or seals
If the halogen bulb's glass cover or seals are dam-
aged, you must replace the damaged parts.
▶
Replace the glass cover or seals.
You can obtain a new glass cover or new seals
from our after-sales service.
→
"Customer Service", Page 38
13.4 Replacing the door seal
If the cooking compartment's outer door seal is defect-
ive, you must replace the door seal. Replacement seals
for your appliance can be obtained from our after-sales
service. Specify the E number and FD number of your
appliance.
1.
Open the appliance door.
2.
Remove the old door seal.
3.
Push the new door seal in on one side of the cook-
ing compartment and then work it in all the way
round.
The joint must be at the side.
4.
Check that the seal is correctly fitted, especially in
the corners.