Neptune 13458-000, Руководство по установке и обслуживанию

Страница: 109 / 150

Self-Diagnostics (Self-Test)
If the push button is held for four seconds, the ProStar goes into
automatic self-diagnostics. The button must be released to start
the self-test. See Table 22
The push button can be used to toggle through the displays
faster. The entire self-test takes 30 to 45 seconds. The load is
turned on for 0.1 seconds and can flash during the test. A
short or overload condition could cause a controller restart.
Display Battery Status
8.8.8 Self-test started, checking the digital meter segments
12u System voltage (12/24/48)
15A ProStar current rating
r1.5 Software version installed
E04 Fault detected (see Table: 12 on page 1 for fault error list)
--- Display if no fault is found
25c Temperature measured at the controller remote
rP Temperature probe is detected (if connected)
25c Temperature at the remote probe (if connected)
SEn Battery sense detected (if connected)
S-2
Battery selected position (1, 2, or 3)
Example: Position '2" is the desired position for AGM batteries
J-1 Telecom noise jumper cut (change to on-off regulation)
END End of self-test
END---END Display; continues if no error was detected
END END Display; continues if an error has been detected
Table 22 – Self-Test Display Examples
R900 Gateway Installation and Maintenance Guide 91
Appendix A Solar Power Information