EnergyBar 6 - Setup Guide
Page 1
WELCOME
Congratulations on your purchase of the Apex EnergyBar 6! The EnergyBar 6 allows the
Apex system to control up to six 230 volt items such as lights, pumps, fans, heaters,
chillers and more.
PHYSICAL INSTALLATION
The EnergyBar 6 should be securely mounted in a location free from moisture. Use wood
screws through the mounting tabs or if mounting on drywall, use drywall anchors
(mounting screws and anchors not included).
•
Mount the EnergyBar 6 above the water line of the aquarium.
•
Be sure to utilize drip loops on all power cords and AquaBus cables plugged in to
the EnergyBar 6.
•
Plug the EnergyBar 6 into a circuit protected by a Ground Fault Circuit Interrupter
(GFCI).
WARNING: Water damage will void your warranty! Mount the EnergyBar in a
location safe from moisture exposure.
AQUABUS CONNECTORS
The EnergyBar 6 communicates with and provides power to the Apex base, Apex Display
and Apex accessory modules through the AquaBus connector. The EnergyBar 6 has four
connectors to connect AquaBus Accessories. There are no limitations on the order
AquaBus accessories can be connected or to which AquaBus ports accessories must be
connected. The total length of all AquaBus cables should be limited to 200 feet. Please
see the AquaController Apex Installation and Getting Started Guide for more information.
WARNING: NEVER plug standard USB devices into any AquaBus connector or
AquaBus accessories into computer USB ports. Damage to the AquaBus accessory
and/or USB device may result.
OUTLETS
The EnergyBar 6 provides six switched 230V outlets. They are numbered 1 through 6 as
illustrated below. All outlets are switched with relays and can power items up to 8 amps
each. The total current draw for all active outlets must be less than 10 amps. Please
see the AquaController Installation and Getting Started Guide for more information on
monitoring and programming the EnergyBar 6 outlets.
Содержание EnergyBar 6
Страница 1: ...EnergyBar 6 Setup Guide...
