BT000F/020F/060F/080F
Specification & Installation instruction
2
Mechanical installation
1.
Manually close the damper blades and positioned the
actuator at 0º or 90º.
2.
Slide the actuator onto the shaft.
3.
Tighten the nuts on the “U” bolt to the shaft with a 8mm
wrench to a torque of 60 in.lb. [6,7 Nm].
4.
Slide the mounting bracket under the actuator. Ensure free
movement of the slot at the base of the actuator. The
bracket pin must be placed in the mid distance of the slot.
5.
Fix the bracket to the ductwork with #8 self-tapping screws.
Wiring Diagrams
Models BT000F & 020F
Models BT060F & 080F
3 wire / 2 position
(ON-OFF)
2 wire / 2 position
(ON-OFF)
3 wire / 3 point floating
4 wire / 3 point floating
PC Board
BBT1060A
Dip switch
Reset button
LED
Terminal
1 2 3 4
ON
1 2 3
Dip switch settings
Stroke adjustment
To adjust the stroke, press and release the reset button to start the auto-stroke process. The LED should be illuminated.
•
First option:
The actuator will then travel in both directions to find it's limit.
The LED will extinguish, the process is complete.
•
Second option:
When the desired end position is reached, press and release the reset button. The actuator will now return back to its
origin position. (you can also press and release the reset button when It's reaches the origin position)
The LED will extinguish, the process is complete.
CLUTCH
MOUNTING
BRACKET
COMMON (-)
SUPPLY (+)
DRIVE
CW
1
2
3
4
DRIVE
CCW
COMMON (-)
SUPPLY (+)
DRIVE CW
1
2
3
4
COMMON (-)
SUPPLY (+)
DRIVE
CW
1
2
3
4
DRIVE
CCW
COMMON (-)
SUPPLY (+)
DRIVE
CW
1
2
3
4
DRIVE
CCW
ON
1 2 3
Rotation: CCW
Fail safe return at 90º
Not used
ON
1 2 3
Rotation: CW
Fail safe return at 0º
Not used
