Neousys Nuvo-6108GC Series, Руководство пользователя

Страница: 7 / 115

Service and Maintenance/ ESD Precautions
Safety Precautions
Read these instructions carefully before you install, operate, or transport the system.

Install the system or DIN rail associated with, at a sturdy location

Install the power socket outlet near the system where it is easily accessible

Secure each system module(s) using its retaining screws

Place power cords and other connection cables away from foot traffic. Do not
place items over power cords and make sure they do not rest against data cables

Shutdown, disconnect all cables from the system and ground yourself before
touching internal modules

Ensure that the correct power range is being used before powering the device

Should a module fail, arrange for a replacement as soon as possible to minimize
down-time

By means of a power cord connected to a socket-outlet with earthing connection

This product is intended to be supplied by a Listed Power Adapter or DC power
source, rated 24Vdc, 16A, Tma 60 degree C and 5000m altitude during operation.
If further assistance is required, please contact Neousys Technology

If the system is not going to be used for a long time, disconnect it from mains
(power socket) to avoid transient over-voltage
Hot Surface Warning
HOT SURFACE. DO NOT
TOUCH . "ATTENTION: Surface chaude. Ne
pas toucher."
WARNING!
Components/ parts inside the
equipment may be hot to touch!
Please wait one-half hour after
switching off before handling parts.
Battery Warning

Batteries are at risk of exploding if incorrectly
installed

Do not attempt to recharge, force open, or heat the
battery

Replace the battery only with the same or equivalent
type recommended by the manufacturer