TROUBLESHOOTING
If there is insufficient pressure coming
from the PowerJets, try closing off some
PowerJets by adding more nozzle
covers (Step 2). This will increase the
water pressure available to the
remaining PowerJets.
If the flow rate is too low try using a
different faucet where the water
pressure might be higher. Typically,
faucets near the front of the house or
main line have better flow rates.
Spray Power Insufficient
If your flow rate is still too low you may
need to increase your water pressure
by adding a booster pump.
Check to see that your filter has round
flanges. Flanges that have other
geometrical shapes or flanges that have
handle tabs will not rotate.
Make sure all filter pleats are wet first.
A dry filter will get soaked on one side
first and the unbalanced weight can
prevent the filter from making a
complete a rotation.
Filter Does Not Rotate
Heavy filters might have difficulty
properly gripping the support rods. If
the support rods are turning and the
filter is not rotating, try using grip
sleeves (not included with the Blaster
1000). Call Neoterics for support.
Water leaks during use
It is normal to observe some water
escaping from around the support rods
– the unit design allows for this and it
will not affect the performance. With
higher water pressures some water may
also escape from around other seals
and the main housing, but this too will
not affect the unit’s performance.
Water stays in device
There is a small drain hole in the bottom
of the main housing to help drain the
water left in the unit after use.
You can turn the nozzles down on the
PowerJet to drain the water more
quickly. However, there will always be
some water that remains in the device
after use.
Содержание BLASTER 1000
Страница 1: ...INSTRUCTIONS...
