27
ENGLISH
3.7
Job Selection or Fill & Start
When you are ready with the preparations (paragraph 3.2 to 3.6) continue using the Fill &
Start function (see 3.7.1 ”Using Fill & Start” on page 27) or select another job and
perform a test run (3.7.2 ”Select Another Job” on page 29).
The Fill & Start feature determines automatically its job settings by measuring the sizes of
documents and envelope. From all feeders that are loaded one sheet will be taken. Based
on the maximum document length (which is also the length of the document-set) and the
length of the envelope the fold type is determined.
3.7.1
Using Fill & Start
When Fill & Start
is started, the machine will pick one sheet from each filled feeder. The
picked documents will be folded (if necessary) and inserted into an envelope.
Only the feeders that feed successfully will be selected. In the Fill & Start job only the
Double Feed Control (DFC) of the upper feeder will be selected (automatically).
Note
Fill & Start cannot be used together with linked feeders and multifeed functionality.
The function Fill & Start is not possible in the no envelopes mode or with usage of
envelopes with open flap.
Note
Before starting Fill & Start, be sure that no documents or envelopes are left in the
machine.
1. Load envelopes.
2. Load the documents face up and leading.
Place the address carrier in the upper feeder.
3. From the “main menu (1)”, press
.
The “Fill & Start” menu is displayed.
4. Press
to load one envelope to
the insert position in the machine.
The envelope is visible through the window in
the top cover.
