16
Job Settings (Supervisor)
Caution
Job settings normally will be changed by a service engineer only. Therefore first consult
the supplier’s Helpdesk before changing any settings. Changes to the job settings can
result in malfunctioning of jobs.
The “job settings” menu (supervisor) can be opened
from the “supervisor menu”. From this menu system
parameters can be set. The “job settings” menu
shows the following functions:
•
: opens the “mode menu” to set
the output mode for a job (see ”Mode Menu” on
page 16).
•
: opens the “document offset”
menu to set the document offset in a set of
documents for a job (see ”Document Offset” on page 17).
•
: opens the “BRE offset” menu to set the BRE offset on or off (see
•
: opens the “flap closer” menu (see ”Flap Closer” on page 18). Use
this function to improve the envelope sealing process.
Mode Menu
When selecting from the “supervisor menu”
,
, the “mode menu”
appears.
In this menu for each of the jobs 1 through 25 and
Fill & Start a choice can be made between output
Mode 1 and Mode 2 using the
button. Mode 2 is
the default setting.
Mode 1 focuses on the versatility of paper
parameters (paper thickness; document length), i.e.
correct operation under even extreme paper conditions.
Mode 2 focuses on high speed and is achieved as follows:
•
During multi feed (more than one page from one feeder) the movement on the
collator is minimal. In mode 1 the divert unit will be used for completing the collating
process (less paper on paper transport).
•
During the transportation of a set from the collator into the Folder, the next set is
going into the collator already. This results in temporary overlapping sets with two
different transport directions. In mode 1 the set has left the collator completely before
the next set enters the collator.
