Neopost AS-Orbit Base R2L, Инструкция по монтажу, Страница: 7 / 12

7
24 Remove the existing light sensor bar and assemble it on
the new aluminium profiles. Remove two screws, the
figure shows only one removed screw.
25 The new position of the light sensor unit is on the right
side of the printer.
26 Now it’s necessary to turn the base plate of the print
units by 180°. For this we have to incline each unit with
the base plate on top. Remove the market screw.
27 The figure shows the inclined print unit. Remove the 4
screws.
Attention: Make sure the spacer underneath the base
plate don’t fall on or into the conveyor, for this cover
the transport belt with paper.
28 The figure shows the removed base plate and the
spacers.
29 Turn the base plate to 180° and reassemble the base
plate.