Manuel PLIMOA
6
2.3 Brake adjustment:
5mm Allen Key
Screwdriver
2.3.1
V-type front brake:
The front brake is operated by the left lever on the handlebar.
Completely tighten the nut on the brake lever, this feature will allow you to compensate later for the natural
slakening of the brake cable.
Loosen the cable clamp and pull the cable until the pads are pushed against the rim. Tighten the cable clamp
(particular attention is to be made to each end of the sheath which is to enter without forcing into the housing
of each rigid end side brake lever and V-Brake).
The pads are properly adjusted when they are in equal distance from the rim. The final adjustment is done by
tightening the screws mounted on the support pads with a screwdriver (distance of about 0.1 to0.5 mm of the
rim).
Your setting is correct when the wheel turning freely, stops suddenly.
