12
Caution:
Do not apply excessive force when inserting a memory card, in order
to avoid damage to the device. To insert a memory card, insert the MicroSD card
into the slot until it locks (until it clicks), if necessary, use a needle to insert a card.
To remove a memory card, press the card until it clicks and remove a card from
the slot, if necessary, use a needle to insert the card.
В. Then plug the charger cable into the Mini-USB connector located on the
device, and insert the charger into a cigarette lighter plug. Start the engine, the
device automatically turns on.
Power On/Power Off
1. Automatically: automatically activated when the engine is started and
switched off when the engine stops working. When the engine starts (power is
supplied to the 12/24V car socket) the device will automatically start recording.
After switching off the engine (12/24V car socket power outage) the device
automatically stops recording and saves recorded files.
2. Manually: when the device is connected to the power source and car engine
works, press Power On/Power Off button and hold a while to switch on/switch
off the device.
Loop recording
1) Insert MicroSD card to a memory card slot and the loop recording mode
automatically turns on.
2) Duration of video can be 1/2/3/5/10 minutes. It is recommended to set a 3
minutes’ cycle.
3) When the memory card is full, in order to record new video the device will
automatically replace old video files except for the files protected from deletion.
4) Video files shot in the loop recording mode are saved in folder: \DCIM\Movie.
Insert MicroSD card to a memory card slot and the loop recording mode
autmatically turns on.