Home Tab
This tab is used to switch on, off and restart the controlled power outlets.
General Tab
This tab is used to:
- attribute a label to the ePowerSwitch 8G and its 8 controlled power outlets,
- define all IP parameters (IP Address, Subnet mask, Gateway and Port number),
- permit or deny the use of the ePowerSwitch Finder program,
- permit or deny the configuration of the ePowerSwitch 8G through HTTP.
Accounts Tab
This tab is used to attribute a name and a password to the administrator and 8 users. It also
enables you to define the power outlets each user can control.
Security Tab
This tab is used to set Network Security Masks. For all details about this features, please refer
to chapter 6 "Security parameters configuration".
Options Tab
This tab is used to define individually the default status (On, Off or last state memorised) of
each power outlet after power up and the delay for the restart function of each power outlet.
Misc Tab
This tab (miscellaneous) indicates the number of Power Up and switching cycles from OFF to
ON for each controlled power outlet.
These values can be set to 0 using the function /RC (Reset Counter) using a Terminal
Connection (see chapter 5 Configuration using a Terminal Connection).
Supervision 1 to Supervision 8 Tab
These tabs are used to define the IP addresses of the devices which have to be supervised as
well all the corresponding parameters. The ePowerSwitch 8G can supervise IP devices by
pinging specific IP addresses and/or scanning specific port numbers.
Remark:
the supervision function works only if the corresponding power outlet is switched ON.
The Button "
Apply changes"
saves all the configuration parameters.
The Button "
Discard Changes"
cancels the changes of the corresponding tab.
The Button "
Exit"
enables you to quit without saving the configuration parameters.
ePowerSwitch-8G User's Guide
