Neodrives Z20, Руководство пользователя

Страница: 24 / 56

1.
1.
3.
2.
2.
24
// 3 The system
Fixing the display on the Twistlock
If required, you can attach the display to the Twistlock.
Use a 1.5 mm Allen key to do this.
Connecting the display with neoTwistlock
1.
neoTwistlock is mounted.
2.
Set the display at a 90° angle, turn clockwise to open it
3. Finished
Removal
Turn the display on the mounting plate approx. 90° counterclockwise. The electrical
connections are disconnected and the display can be removed. Before removing,
the system (d pedelec) should be switched off
→
see chapter 4.1.
However, there will be no damage if you mount or dismount the display while
the pedelec is switched on.
Notes:
To protect your pedelec from accidental use by third parties or theft, the display
should always be removed from the handlebar when not in use. However,
removing the display does not replace securing your pedelec against theft, e.g.
with a suitable bicycle lock. The system should be switched off before removing
it. However, there will be no damage if you mount or dismount the display while
the pedelec is switched on. Approximately 15 seconds after turning, the system
goes off. The light, if switched on, also switches off after approx. 15 seconds. After
turning off the display, wait approx. 30 seconds until you put it back on again.
Otherwise, a successful system initialisation cannot be guaranteed.
3.4 Starting the system
The USB charging port or the
softkeys (only for the TFT
display) are located at the
bottom.