Neocom TRBOnet Swift A200 Скачать руководство пользователя страница 3

Страница: 3 / 8

How to reset Swift A200

If Swift A200 connected to the PC with a micro-USB cable doesn't display any information, or the

device configuration cannot be retrieved by means of Swift CPS, just perform the following steps:

•

Dismount the housing by unscrewing four screws on the rear

panel and remove the entire board assembly.

•

Remove the SD card from the card slot.

•

Connect the board assembly to the PC with a micro-USB cable

and check if the device starts correctly with the SD card removed.

If the device starts correctly, proceed with formatting the SD

card (see Appendix 1).

Note: A correct start means that service information is shown

on the OLED display and the device configuration can be

successfully retrieved by means of Swift CPS.

If the device doesn't start correctly, try the following steps to

restore the device's firmware:

Содержание TRBOnet Swift A200

Страница 1: ...rg 199004 Russia US Office Neocom Software 15200 Jog Road Suite 202 Delray Beach FL 33446 USA Internet Email info trbonet com WWW TRBONET COM Telephone EMEA 44 203 608 0598 Americas 1 872 222 8726 APAC 61 28 6078325 Radio over IP Gateway TRBOnet Swift A200 How to Reset ...

Страница 4: ... 1 9 0 18 or higher Note that the computer must be connected to the Internet to automatically install STM32 microcontroller drivers Carefully disassemble the board assembly of Swift A200 o Remove the AUDIO board o Remove the OLED board o Separate the CPU board from the GATE board ...

Страница 5: ...uit the two VIA contacts located next to the battery o While keeping the contacts short circuited connect the CPU board via a USB cable to your PC with the installed Swift CPS When connected via USB the CPU board with the short circuited contacts will be detected by the Device Manager and by Swift CPS as STM32 Bootloader or STM Device in DFU Mode depending on the OS version ...

Страница 7: ...means that service information is shown on the OLED display and the device configuration can be successfully retrieved by means of Swift CPS If Swift A200 starts correctly Reassemble the boards Check the functionality of the entire board assembly o Connect the device to the power supply network and radio o If the check is successful insert the board assembly into the housing ...