Neo Pro BORREGO, Руководство интегратора

Страница: 6 / 16

6
Borrego Matrix Switch User’s Guide (DOC42-00004-D_NeoPro-Borrego.doc)
and reboots, MS Windows will remember what COM port this
device was assigned.
Rear Panel IR
The rear panel connector labeled “IR” is for direct connection to a
control system. It is a 3.5mm 2 pin jack, and accepts unmodulated
IR. It is polarity insensitive, however normally the ‘tip’ is the
active signal, and the ‘sleeve’ is the ground.
Note: Some IR repeater systems are designed to work only with
their own IR blasters. Many integrators will cut these blaster cables
and add a 3.5mm plug on the end. In some cases this will work
fine, however some low end IR repeater systems will have too
much noise in their signal, and can prevent signals from being
properly decoded. Your results may vary.
Power
Once all the input and output connectors are in place, connect the
supplied power cable to the AC input. If you are not in North
America, you may use your own standard IEC320 power cable
with the Borrego matrix switch. The Borrego will detect whatever
voltage is supplied (from 90V to 240V AC), and adjust
accordingly.
Rack Mounting (optional)
The product ships with the rack mount ears detached from the unit.
This is to prevent damage to the chassis during shipment. Use the
supplied screws to attach the ears. The rack ears are universal, so
they fit on either side.
The chassis is a 2 rack units high only when the bottom feet are
removed. Removal requires a Philips screwdriver. Be careful when
turning over the unit as to not scratch the top paint