4
a. If installing the Gateway into a non-navigation Touareg, then connect
the VW2A adapter to the harness and Neo gateway.
b. All other applications, connect the VW2B adapter to the vehicle har-
ness and to the Neo gateway.
Plug the black micro-fit 24-pin connector on the VW2 harness into the
Gateway Neo Gateway box.
8. To complete the installation secure the Neo Gateway (Gateway) and
HD Radio tuner (HDRT) (Touareg only) into the cavity behind the dash.
Be sure that the cables and interface modules are not near moving parts
or sharp metal edges as they may damage the cables. To prevent rattling
noises inside the dash, use zip ties, or electrical tape, or other fasteners
to mount the interfaces to the factory wiring or installed audio compo-
nents (for example under the factory Satellite tuner (if present).
9. With all connections made, reconnect the vehicle’s battery, insert the
key into the ignition, and turn the vehicle on. Check for proper operation
of the Neo Gateway and HD Radio Tuner before
reinstalling the factory dash panels.
10. When first powering up the vehicle with the radio reconnected,
“CODE” may appear on the screen. This is a safety feature of the VW
radio. If you see this message, DO NOT enter a code, simply let the
radio sit on this screen for about 10 seconds, then turn the vehicle off.
Disconnect the gateway harness from the vehicle. Reconnect the gate-
way harness to the vehicle. Normal operation should resume.
11. NOTE: The first time that you access the Gateway, your radio may
display “DEV INIT” while the device is initializing. If this is displayed,
please wait one minute then cycle the ignition off and on. Access the
gateway again to begin normal operation.
7. Basic Mode
If you have configured your Neo Gateway to operate in Basic Mode by
setting the dipswitches as described in section 5, read this section to
learn how to use the supported features. If not, please proceed to section 8.
Basic mode is accessed by pressing the “CD” button twice to switch the
radio to the CD changer source.
Use the iPod click wheel to access your favorite music. When the iPod
is playing, turn the tune knob Clockwise, or press the
“SEEK▲”
button
to change to the next track. Turn the tune knob Counter-clockwise to go
back to the previous track.
