•
Ensure cable is placed such that no trip, entanglement, or strangulations hazards are likely to
occur
•
Ensure the tank is placed on a steady, flat, and even surface.
•
DO NOT
use live fish in this tank.
•
DO NOT
attempt to move the product when filled with water or when plugged to the mains.
•
ALWAYS
disconnect from the mains when cleaning or changing the water.
•
Persons (including children) with reduced physical, sensory and mental capacities, or lack of
experience and knowledge of this product,
MUST BE
supervised by a competent person responsible
for their safety.
8. Instructions
To Insert Batteries:
1.
To insert batteries, remove the screw from battery cover and insert 3 x AA batteries.
2.
Be sure to insert batteries with correct polarities and always follow the product and battery
manufacturers’ instructions.
3.
Once batteries have been inserted, replace cover and always re-insert the screw in.
To add Water and Jellyfish
1.
Remove the lid from the top of the tank.
2.
Remove the rubber cap.
3.
Fill the tube to the top with distilled water.
4.
Turn on from on/off switch
5.
Add 1-2 drops of dish washing detergent and wait for a minute.
6.
Turn on the power at least 30 seconds before putting the jellyfish into the tube.
7.
Carefully hold jellyfish by the tentacles to put into the tube. Fill inside of the body with water
before letting go of them.
8.
Try to avoid air bubbles in body of jellyfish. If necessary, use a straw or stick to help turn
them to remove air bubbles.
9.
Put rubber cap back on. Put the lid back on.
10.
Please allow some time for the jellyfish to start swimming correctly around the tube, as it can
take some time.
11.
Change water occasionally when dirty.
Battery Warnings:
•
Batteries should only be inserted or changed by a competent adult.
•
Non-rechargeable batteries are not to recharged.
•
DO NOT
mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
•
NEVER
mix old batteries with new batteries (replace all batteries at the same time)
•
Remove batteries from product before extended storage. Always remove old or exhausted
batteries from the product.
•
The supply terminals are not to be short circuited.
•
Check that the contact surfaces are clean and bright before installing the batteries.
•
DO NOT
bury or burn batteries.
•
Recycle used batteries responsibly.
DO NOT
dispose of in household waste.
For more information, you can visit our website
www.nenko.com
.
