Note:
You must turn on the projector to put the wheel motor in the correct position.
The opening at the top of the magnet must be facing the top of the projector.
To re-attach the magnetic adapter, make sure that the flat side of the axis is facing the top of the
projector. Place the magnetic adapter on the shaft and turn the allen key clockwise.
The magnetic adapter attaches to the projector.
After removing the magnetic adapter, push the wheel onto the axle of the
wheel motor, as shown. This is easier if you turn the effect wheel lightly, with up and down
movements.
To attach liquid wheels, tighten the screw to the axle of the wheel motor, as shown. To loosen the
liquid wheel, unscrew the wheel screw and ensure that the wheel is held vertically and straight. Use
both hands to remove the wheel from the shaft.
5. Connect the power supply to the right side of the projector and plug it into
the wall socket. The projector turns on by holding down the button.
6. To change the quality of the projected effect, turn the slider on the lens forwards and backwards
until the desired focus is reached.
7. The maximum image size must not exceed 4 meters (diameter).
8. To turn off the projector, press the "DIM - OFF - TIMER" button until the light goes out.
9. To dim the image, press and hold the 'DIM
–
OFF
–
TIMER' button until the light output reaches the
desired level.
Note:
With liquid effect wheels, it can take up to 15 minutes for them to start working.
The oil containing these wheels must be warmed up. This heat comes from the projector.
