8
English
1). Master switch.
2). Compressor on light.
3). Lower temperature button.
4). Raise temperature button.
5). Cover.
6). SET button.
7). On / off switch
8). Internal ventilation operation
indicator
9). Water drain cap.
10). Water tray
11). Power socket.
12). Power cord
13). Electronic thermoregulator
14). Ventilation grille
IMPORTANT: This machine contains its own refrigerant which must be allowed to settle after transport. Leave
the machine on a horizontal surface for at least 12 hours after purchase or after any move which might have
stored the machine the wrong way up.
Leave at least 20 cm on each side of the machine to allow free air circulation. Make sure the vent slots are
free and unobstructed.
UK USERS ONLY
HOW TO CONNECT THE CORD TO A U.K. PLUG: IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
• Green and yellow:
Earth
• Blue:
Neutral
• Brown:
Live
Please, read the instructions given below before connecting the cord to a
plug. If in doubt, please, consult a qualified electrician. As the colours of the
wires in the mains lead of this appliance may not correspond with the coloured
markings identifyng the terminals in your plug, proceed as follows: the wire that
is coloured Green and Yellow must be connected to the terminal in the plug
which is marked with the letter E or the Earth symbol (
G
), or coloured Green or Green and Yellow.
The wire that is coloured Brown must be connected to the terminal which is marked with the letter L or
coloured Red. The wire that is coloured Blue must be connected to the terminal which is marked with the
letter N or coloured Black.
SAFETY POINTS FOR REWIRABLE OR MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS1363 13A plug.
• If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded
on plug), the flexible cord insulation should be stripped back as appropriate and a suitable 3 pin plug
fitted.
WARNING: Dispose of a plug that has been cut from the power supply cord, as such a plug is
hazardous if inserted in a live 13A socket outlet elsewhere in the house.
•
Should the fuse need to be replaced an ASTA marked fuse, approved to BS 1362, of the same rating
must be used.
•
Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted
or lost until a replacement is obtained. Make certain that only the correct fuse cover is used and fitted.
• For plugs with detachable fuse cover, the replacement must be the same as the colour insert in the base
of the plug, or as directed by the embossed wording on the base of the plug.
• If the detachable fuse cover is lost a replacement may be purchased from a Service Centre.
• Information for supply may also be obtained from the plug manufacturer.
