Page 4
P: 419.542.7751 ● F: 419.542.6690 ●
800.782.6761
● nemcofoodequip.com
INSTALLATION
Remove the packaging and all packing materials from the Sandwich Press.
Check for any signs of shipping damage.
If shipping damage is discovered, contact the Customer Service
Department at Nemco Food Equipment AS SOON AS damage is discovered
.
LOCATING AND INSTALLING
Verify that you have an area on a counter top is at least 18” wide and is within 6’ of a 30 amp receptacle
that matches the sandwich press plug type.
Only install this appliance in a well-ventilated area. Verify that hot air from other cooking appliances can’t
be drawn into the back cooling fans of the Sandwich Press.
*if the Sandwich Press must be placed
adjacent to a heat source, then a heat shield should be placed between the appliances to protect the
sandwich press. (Failure to do so may void the warranty).
The appliance should be placed on a flat level surface that is suitable for the weight of the Sandwich Press
(135 LBS); adjust the legs as needed.
A minimum of 2 inches (51mm) of clearance at the sides and 2 inches (51mm) behind the unit is required
to ensure there is no interference when opening and closing the upper enclosure. Also, ensure that there
is enough room above the upper enclosure to allow it to fully open.
DO NOT apply any stickers or instructions to the outside of the appliance that interfere with or contradict
the manufacturer’s installed warning labels.
ELECTRICAL INSTALLATION
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.
WARNING
— Improper use of the grounding plug can result in the risk of electric shock.
Consult a qualified Technician if the grounding instructions are not completely understood or if doubt
exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified Serviceman install an
outlet near the appliance.
VOLTAGE REQUIREMENTS
WARNING
– Plugging the unit into an outlet with less than
the required voltage will result in the
unit not performing as designed. Consult a qualified Service Technician if the voltage instructions are not
completely understood or if doubt exists as to whether the appliance has proper voltage.
