Nemaxx SP5-NF, Оригинальная инструкция по эксплуатации

Страница: 3 / 42

Version: 5.0
19.05.2016
3
EN
THIS SMOKE DETECTOR CANNOT FUNCTION WITHOUT A BATTERY
- A NEW BATTERY MUST BE INSTALLED IMMEDIATELY ONCE THE ALARM
SOUNDS SIGNALLING THE BATTERY IS DEAD OR DISFUNCTIONAL
- TEST IT EVERY WEEK
- READ AND FOLLOW THESE INSTRUCTIONS CLOSELY TO MAKE SURE
THIS DEVICE FUNCTIONS TO ITS FULL CAPACITY.
FUNCTIONING, TESTING AND MAINTENANCE
• FUNCTIONING: The detector is operational provided its circuits are supplied by the
current generated by a battery.
When products of combustion are detected, the alarm will sound until smoke can no
longer be detected in the air.
•
TESTING: Test by lightly pressing the test button on the detector until the alarm sounds.
This test activates the auto test function, and the alarm will sound if the electronic circuits
and the battery are all in good working order.
IT IS STRONGLY RECOMMENDED THAT YOU CARRY OUT THIS TEST EVERY WEEK.
If the alarm does not sound during a test, in order to verify whether it is due to the
battery, replace it with a new one and do the test again.
Minimum intensity of the alarm: 85dB.
•
MAINTENANCE: The smoke detector does not require any specific maintenance.
However, you should vacuum the room to ensure it does not detect dust.
DISPOSE OF USED BATTERIES IN DESIGNATED CONTAINERS, LOOK AFTER THE
ENVIRONMENT.
Red diode
(a flash approximately every
40 seconds signals normal
functioning)
Test button
Understanding the different “beep” alarms
- Alarm (regular “beep”)
- Test (2 or 3 “beeps”)
- Dead battery alarm
40 to 50 seconds
Key
“Beep” sound
Silence