- 13 -
WHEEL GEARS/PAWL SERVICE
DO NOT remove both wheels at the same time.
Remove one wheel at a time to prevent use the wrong
parts for the opposite side (left and right sides are different). When removing gears make notes on
position of all washers and retaining rings.
The pawl, inside ratchet gear, has a curved end (side) and a flat end (side). When re-assembling the
ratchet gear and pawl, fill the inside with grease. Re-assemble the wheel and turn wheel, if the brush drive
rotates in both directions, the pawl is assembled
INCORRECTLY
. To be assembled
CORRECTLY
, flip
the pawl over so the brush drive rotates in one direction.
BRUSH REPLACEMENT
1. Remove the hopper bag from lawn sweeper.
2. Only replace one brush at a time.
3. Tip the sweeper forward on housing. Do not remove the hex bolts from double brush retainers.
4. Loosen hex bolts and hex lock nuts from single brush retainers. Slide brush out of retainers, making
note of over-lap bristles position.
5. Install new brush, make sure the over-lap bristles are in the positioned as before
Maintenance and Storage
