other side.
3. Slide the new bush onto the threaded rod and align it with the hole in the arm.
Place the pushing cup (C) up against the bush and slide on the washer (E).
Retain the whole assembly by screwing on the nut with washer (F). Before
commencing insertion ensure that the assembly is aligned with the hole in the
suspension arm as shown in fig.3.
4. Hold nut D with a spanner and then place a second spanner over the nut with
washer attached (F). This should preferably be a ratchet ring spanner for ease of
use and maximum accessability. As the nut is turned, insertion will commence as
indicated in fig.4. Take care not to drive the bush too far into the suspension arm.
Cease insertion when the bush is fully inserted into the arm as shown.
5. Disassemble the extractor and place the separate components in the case
provided.
CANNON TOOLS LTD
Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K.
www.cannontools.co.uk
