Neilsen JD505524, Инструкция по эксплуатации

Страница: 6 / 16

SPECIFIC SAFETY RULES – cont’d
ƒ
TO AVOID INJURY from accidental
starting, always remove the battery from
the tool before installing or removing a
Socket or other, accessory or
attachment.
ƒ
BEFORE STARTING the operation,
jog the Impact wrench switch to
make sure the impact wrench bit
does not wobble or vibrate.
ƒ MAKE SURE the spindle has come to a
complete stop before touching the
impact wrench head or attempting to
change the bits.
ƒ Do not store or carry battery so that
metal objects can come in contact with
exposed metal ends. Do not place the
battery in aprons, pockets, drawers, etc.
with loose nails, screws, keys etc. The
battery could short circuit causing a fire,
personal injury or damage to the battery.
ƒ
Never attempt to open the battery for
any reason. If the housing of the battery
breaks or cracks, immediately
discontinue use and do not recharge.
ƒ Do not charge the battery if it is wet or
shows any evidence of corrosion.
ƒ A small leakage from the battery may
occur under extreme usage, charging or
temperature conditions. This does not
indicate a failure. If however, the outer
seal is broken and this leakage gets on
your skin, follow these steps:
1. Wash quickly with soap and water
2. Neutralize with a mild acid such as
lemon juice or vinegar
3. If liquid gets into your eyes, flush
immediately with clean water for a
minimum of 10 minutes and seek
medical attention.
NOTE: The liquid is 20-35% solution
of potassium hydroxide.
ƒ Do not incinerate the battery. It can
explode in a fire.
ƒ
Do not use an extension cord. Plug the
charger cord directly into an electrical
outlet.
ƒ Use the charger only in a standard
230/240v/50Hz electrical outlet.
ƒ Charge the battery only with the charger
supplied with the drill.
ƒ Do not use the charger in wet or damp
conditions. It is intended for indoor use
only. Do not use the charger near sinks
or tubs. Do not immerse the charger in
water.
ƒ Do not allow the cord to hang over the
edge of a table or counter or touch hot
surfaces. The charger should be placed
away from sinks and hot surfaces.
ƒ
Do not use charger to charge any
batteries other than the drill batteries.
Other batteries may explode.
ƒ Do not operate charger if cord or plug is
damaged. Replace damaged cord and
plug immediately.
POWER TOOL SAFETY
BATTERY & CHARGER
SAFETY
6
SAVE THESE INSTRUCTIONS FOR REFERENCE