Charge the battery only with the charger supplied with the drill.
Do not use the charger in wet or damp conditions. It is intended for indoor use
only.
Do not use the charger near sinks or tubs. Do not immerse the charger in water.
Do not allow the cord to hang over the edge of a table or counter or touch hot
surfaces. The charger should be placed away from sinks and hot surfaces.
Do not use charger to charge any batteries other than the drill batteries. Other
batteries may explode.
Do not operate charger if cord or plug is damaged. Replace damaged cord and
plug immediately.
Do not operate charger if it has received a sharp blow, been dropped or otherwise
damaged in any way. Have a qualified technician examine the charger and repair it if
necessary. Do not disassemble the charger.
For best results, do not charge the battery when the battery or air temperature is
below 50
o
F (10
o
C) or above 105
o
F (40
o
C).
Unplug the charger when not in use and before cleaning or maintenance.
Do not abuse the cord. To reduce the risk of damage to the electric cord or plug,
never carry the charger by the cord or yank the cord to pull the plug. Always grasp the
plug and pull to disconnect. Always keep the cord away from heat, oil and sharp
edges.
OPERATING INSTRUCTIONS
Do not allow familiarity with products to make you careless.
Remember that a careless fraction of a second is sufficient to inflict severe injury.
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when not in use. Removing
battery pack will prevent accidental starting that could cause serious personal injury.
TURNING POLISHER ON/OFF
1. To start the buffer/polisher, place the power
switch in the ON ( l ) position.
2. To stop the buffer/polisher, place the power switch in
the OFF ( O ) position.
The tool’s rotating base moves in random orbital motion.
Battery tools are always in operating condition. Therefore, switch
should always be in the
OFF ( O )
position when not in use or carrying at your side,
when installing or removing the battery pack, and when installing or removing