14.
Do not incinerate the battery pack even if it is seriously damaged or is completely worn out. The battery can explode in a fire.
15.
Never attempt to open the battery pack for any reason. If the plastic housing of the battery pac k breaks or cracks, immediately discontinue
use and do not recharge
.
16.
During charging, the battery must be placed in a well ventilated area.
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of with household waste but in an
environmentally friendly way.Please recycle where facilities exist. Check with your local council
authority for recycling advice.
Recycling packaging redeces the need for landfill and raw materials.Reuse of recycled material decreases
pollution in the environment.Please recycle packaging where facilities exist.Check with your local
council authority for recycling advice.
LED lights do not illuminate on charger
Check the charger is securely plugged into the wall out let.
The battery has a short run time
Ensure the battery is properly charged. It will take 4-5 charging cycles before the battery reaches
optimum charge and run time. On the initial charge, the battery requires 1 hours of charging.
Subsequent charging only requires 0.5-1 hours.
Variable speed trigger is locked
Ensure that the forward / reverse lever is in the correct position; pressed left for forwards direction,pressed
right for backwards direction. If it is in between the two settings the variable speed trigger will be locked.
The
Impact Wrench
is stripping the screw head
Ensure you are not applying to much force to the wrench. Decrease the force by using a slower trigger speed.
Impact Wrench
has cut out during use
Use the battery indicator button to check if the battery has gone flat. If the indicator does not work or
indicates that the battery still has charge, it is likely that the battery’s themal voltage protection has been
activated.This can happen when the wrench has been used for extended periods or worked hard with
large wrench bits or accessories.
Place the battery on the charging cradle for 0.5-1 hours. It will need this time to cool down and for the
protection circuits to be reset.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents.
This is normal and does not indicate a problem.
charger
4
