Neilsen CT4001, Инструкция по эксплуатации, Страница: 10 / 14

Pull out and turn the tool retainer 180
degrees to secure the bit.
To remove the bit, follow the
installation procedure inreserve.
CAUTION:
Always assure that the bit is securely
retained by attempting to pull the bit out
of the tool holder after completing the
above procedure.
The bit without a collar cannot be
retained by the method shown in Fig
(1).
To remove the bit,
follow the installation
procedure in reverse.
OPERATION
Chipping/Scaling/Demolition
Hold the tool firmly with both hands.
Turn the tool on and apply slight
pressure on the tool so that the tool will
not bounce around, uncontrolled.
Pressing very hard on the tool will not
increase the efficiency.
GENERAL
When servicing, use only identical
replacement parts. Use of any other part
may create a hazard or cause product
damage.
DO NOT use solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use clean cloth to remove dirt, dust, oil,
grease etc.
Do not at any time allow brake fluids,
gasoline, petroleum-based products,
penetrating oils, etc. to come in contact
with plastic parts. They contain chemicals
that can damage, weaken or destroy
plastic.
DO NOT abuse power tools. Abusive
practices can damage the tool as well as the
work piece.
DO NOT attempt to modify tools or create
accessories not recommended. Any such
alteration or modification is misuse and
could result in a hazardous condition
leading to possible serious injury. It will
also void the warranty.
LUBRICATION
All of the bearings in these electric tools are
lubricated with a sufficient amount of high-
grade lubricant for the life of the unit under
normal conditions. Therefore, no further
lubrication is required.
CAUTION:
Always be sure that the tool is switched
off and unplugged before attempting to
perform inspection or maintenance.
10
WARNING
!
WARNING
!
WARNING
!
ASSEMBLY & OPERATION
MAINTENANCE