7
ASSEMBLY
When assembling unit, refer to drawings for part location.
1. Place the base on a flat surface and fasten the column assembly.
2. Slip the table assembly onto the column and slide it down until it rests on the
base.
3. Install the table lock handle onto the table assembly.
4. Position the head assembly on top of the column and secure it in place by
tightening two headless screws.
5. Assemble handles into the feed shaft on the right side of the drill press head.
6. Thoroughly clean the inside of the chuck taper and the spindle taper with a
clean soft cloth and solvent. Insert the chuck onto the spindle. Tap sharply
using a piece of wood to prevent damage to the chuck.
7. Place the belt on the pulley, slide the motor until not the belt is moderately tight.
Tighten the slide bar belt on the drill press head.
8. Be sure the drill press switch is off and the unit plugged in. Rotate the pulleys
by hand to check the alignment.
9. Close the Cover. Plug the cord into a grounded outlet. "JOG" the drill press on
briefly to be sure that all parts are clearing the guards.
TABLE ADJUSTMENTS
1. Height adjustments: To adjust table, hold the table with one hand and loosen
table lock handle. Adjust the table to the desired position and retighten the lock
handle.
2. Tilting worktable: Loosen the pivot bolt. Remove the small locator pin. To do
this,"loosen" the nut until the pin easily slips out. Tilt the table to the desired
angle up to 45
o
and retighten bolt. Reinsert the locator pin when returning the
table to zero degree.
3. Rotation of worktable: Loosen the table (item 7 in assembly diagram). To obtain
more distance between the chuck and the table. The worktable can be rotated
180
o
and the base can be used as a worktable. This will permit the drilling of
larger objects.
INSTALLATION
1. After installing the drill press, use the kerosene to wash out the anti - rust oil
protective coating applied at the factory. Then wipe drill with lubrication oil.
2. Install your drill press in flat, sturdy floor or surface.
a. Check if the drill press in shaking when the motor is switch "ON".
b. Check if the spindle shaft moves smoothly.