Neilsen CT3656, Оригинальное руководство пользователя

Страница: 8 / 16

8
4.2 Adjust blades pressure with the adjustment cap
Before putting into operation, make adjustment as follows:
Before clipping:
With the machine switched off, we should tighten the adjustment cap (Figure 2, part 5) until it
can clip hair smoothly( Figure 2 ).
During clipping
Pay attention to that the pressure of the blade should not be set to a value that is too high,
otherwise the clipped hair may gather in the blade. If the adjustment cap is not tightened in
the beginning of operation, clipping will be laborious or even cannot be carried out.
Set the blade pressure properly:
If the adjustment cap is too tight, the blade pressure will be too high which will result in fast
blade heating, fast wear and loud noise. In this case, the adjustment cap should be unscrewed
slowly until the noise reaches a normal level and proper clipping result is achieved. During
unscrewing, feel the pressure and set pressure properly according to need.
Hair can be gathered between the clipper blades if they are insufficiently tensioned at the
beginning of clipping. It is harmful to the further clipping progress. If this happens, the clipper
blades must be disassembled, cleaned, oiled and re-fitted.
The clipping system works with much less pressure in comparision to traditional animal clipping
machines.
4.3 Lubrication
Before and During clipping
A thin layer of oil on the upper and lower blades (Figure 3) is essential for clipping well and so
as to increasing the life of the machine and the clipper blades. All other moving pares should be
well-oiled at the clipping head. Place a few drips oil on the clipper blades and pour some into
the lubricating holes which lies on the clipper head (Figure 3) .
It cannot meet the ISO VG15 specification unless using our the special oil or the paraffin oil.
This oil is nontoxic and produces no irritation on contact with the skin or the mucous
membranes .This paraffin oil degrades to 20% after 21 days.
Is the oil good impacts on the clipping result which is satisfied . The clipper blades which was
oiled by improper oil will overheat. It will reduced the life of the clipping blade.
The clipping blades and clipper head must be adequately lubricated at least every 15 minutes
so that they cannot be dried out.
4.4 Switching On/Off
There are two positions on the slide switch (Figure 1) .
Position on: Machine switched on
Position off: Machine switched off
We always use the slide switch ( Figure 1 ) when it need to be switched the machine on or off.
Check the switch position before replace battery cartridge.