Neilsen CT3320, Инструкция по эксплуатации

Страница: 9 / 16

7
7. USING THE TOOL
7.1 POWER SOURCE
This tool applies to normal air compressor and is designed to operate in clean,
dry and compressed air at regulate pressures between 5~8bar.
Place two or three drops of air tool oil into the tool’s air inlet at the beginning of
workday and try it twice or three times.
7.2 How to Use
1. Make sure that the tool is off and
disconnected from the compressor.
Pull the pusher back, engaging the
Latch.
2.Load the nails by holding the nailer
down with the magazine tilled
downward. Insert the nails into
magazine.
3. Release the Latch and pusher,
slid the pusher against the nails.
4. Connect with air source.
5. Hold the handgrip with one hand and press the cover with another hand.
6. Depress the safety and in touch with the workpiece.
7. Shoot the trigger when the tool point to the workpiece.
8. Remove the tool from the workpiece after nailing.
9. After use, to prevent accidents:
a. Release the Trigger.